In order to make the bubble film bag making machine more efficient, we should do the corresponding preventive work before using the bubble film bag making machine to avoid equipment failure and unable to continue operation. This will affect production efficiency. Let's take a look at it!
The bubble film produced by the bubble film bag making machine can effectively protect the products, so it has been widely used in many industries. Because the bubble film has good performance, it can provide good protection for all kinds of products. And the high-quality bubble film is often made by the bubble film bag making machine. How to solve the problems in the production process? How can we do a good job in prevention? Special personnel shall be assigned to operate the bubble film bag making machine. It is not allowed to idle the extruder screw when there is no material, so as to avoid scratching the screw and the barrel. After shutdown, if there is material stored in the barrel, before starting the machine again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the machine can be started after holding for more than 30 minutes. It is strictly prohibited to start the machine before the temperature reaches the requirements, so as to avoid damage to the machine parts. When the air cushion membrane machine is feeding in the hopper, it must be kept clean and prevent metal sundries, sand and small tools from entering the feeding port to prevent damage to the barrel and screw. In case of abnormal noise during operation, it should be stopped immediately for treatment. In order to avoid such failures, it is very important for us to maintain the bubble film bag making machine. The screw of the air cushion membrane machine is taken out of the barrel for some reason, and shall be properly handled to prevent deformation. If it is not installed in the barrel for a long time, the screw must be hung vertically to prevent damage, bending and permanent deformation. The surface of the barrel and the screw shall be coated with anti rust oil for protection. After the bubble film bag making machine is shut down, if there is material stored in the barrel, before starting again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the machine can be started after holding for more than 30 minutes. It is strictly prohibited to start the machine before the temperature reaches the requirements to avoid damage to the machine parts. The bubble film bag making machine shall be regularly overhauled. The die head shall be thoroughly cleaned every three months, the lubricating grease shall be replaced for various bearings, the lubricating oil shall be replaced for the reducer every six months, and the overall equipment shall be overhauled every two years.
